Sima STP-1000T Especificaciones

Smooth Start Series User Instructions for Model STP-1000T Power Inverter Model STP-1000T

inverter to shut down or the fuse to blow. Repeated use of excessive power draw can cause failure of the power inverter. How to calculate power usage

Battery Life Chart Power Usage Approximate 12 volt Current Typical operation time with 50 amp-hour car battery Typical operation time with 100 amp-ho

How the Inverter Works The Sima Products Corporation power inverter has two electronic sections. The first section converts 12 volts DC to approximat

Troubleshooting Problem Cause Solution Unit does not operate Input voltage is below 10 volts Attach to proper supply Fuse blown Determine cause

Product Specifications Key Features STP-1000T Input 12 - 15 volts DC Input no-load current < .6 A Output type modified sine wave Output, Watts,

Limited Warranty Sima Products Corporation (“Company”) warrants that if the accompanying product proves to be defective to the original purchaser in

Safety Information IMPORTANT Read all the Cautions and Warnings before installing and using the power inverter. The inverter must be properly inst

Table of Contents Safety Information ...2 Introd

Introduction Congratulations on your purchase of a Sima Products Corporation power inverter. It provides 115 VAC anywhere you have 12 DC volts in yo

Overview of the Power Inverter The STP-1000T power inverters are electronic devices that convert the low voltage 12 VOLTS DC from a battery or other

Installation Installation Overview There are three basic steps you need to follow when installing the power inverter. 1) Mounting: Mount the invert

Step #2: Wiring Inverter to 12 volt Power The power inverter requires connection to a standard 12 volt DC power source as found in most cars, trucks,

Permanent Installation Figure 3, Wiring the STP-1000T power inverter Caution: Always use adequate wire size and fusing for any installation Wiri

• Double check all wiring for proper polarity. • Install the fuse and reconnect the wire to the battery. Note, a slight spark and beep from the inv