Sima STP-1500T Manual de usuario descargar pdf (Pagina 11)

SIMA User Manual Electrical Connection

page 11 of 63

5. Electrical Connection

Work on the electrical system or equipment must only be carried out by a skilled

electrician himself or by specially instructed personnel under the control and

supervision of such an electrician and in accordance with the applicable electrical

engineering rules.

5.1.1. Connection of SIMA

SIMA can be supplied with different voltages. Before inserting the power supply plug ensure that the

mains switch is in position OFF and verify that the existing power supply on site is equivalent to the

power supply of the SIMA Master Station.

Insert all required plugs according to the connectors diagram (clause 12.4, p. 58).

It is recommended that the shielding of all interface cables is properly connected to the ground

potential in the control cabinet (use shielding clamps).

5.1.2. Connection of actuator / controls

Perform the connection of the actuator / controls according to the operation instructions enclosed

with the delivered AUMA actuator.

For more details, observe the complete operation instructions of AUMA actuator controls,

see

5.1.3. Connection of additional field devices

As SIMA is based on standard fieldbus communications, other field devices may be integrated in the

scope of control on request.

If repeaters are used, be sure to take care of the power supply, as a loss of this

energy supply will lead to a complete failure of the repeater and therefore to a loss

of communication to all succeeding actuators.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sin comentarios

Sima STP-1500T Manual de usuario Pagina 11