Sima STP-1500T Manual de usuario descargar pdf (Pagina 17)

SIMA User Manual User Interface

page 17 of 63

6.5. Actuator faceplate

When selecting an actuator its faceplate is displayed:

The displayed information in the window title depends on:

act. tag Y/N

content of window title

example

“non”

loop redundancy

without “Actuator address no”

“Actuator 47”

with “<act. Tag> - Actuator address no.

“MOV123/3A – Actuator 47”

loop redundancy

without “Actuator pos. in loop (address

no.)”

“Actuator 45 (Addr.47)”

with “<act. Tag> - Actuator pos. in loop

(address no.)”

“MOV123/3A – Actuator 45

(Addr.47)”

The parameter group C

URRENT STATE shows the input information from the actuator:

LOSE / OPEN At the top of CURRENT STATE the actual position is displayed as a bar graph

and in per cent of total travel

OSITION Display whether the actuator is in an endposition (open position / close

position) or has reached its setpoint

ORQUE SW Display the torque switch

IMIT SW Display the limit switch

ELECTOR SW Display the position of the selector switch of the local control unit (Local /

Off / Remote)

“Message window”

Check box (

)

AULT(S)

OT READY

ARNING(S)

in this window a more detailed actuator status information is displayed

indicates active messages of the type besides

Fault messages of the actuator, like torque or temperature error

The actuator cannot be operated by the SIMA: Selector not remote,

actuator locked, wrong commands, etc.

Warnings signals: signal break, travelling time error, etc.

For more details about messages see operation instructions, Appendix F.

1 2 ... 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Sima STP-1500T Manual de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Adaptadores E Inversores De Energía Sima STP-1500T